Genuine Enerpac repair parts and kits for pullers, cutters, presses, nut splitters, flange spreaders and punches, including replacement blade sets and service kits. Not sure it fits? Send us your tool's model number and we will confirm the part before it ships.
Find your tool family
| Tool family | Example Enerpac models | Parts often replaced | Shop the tools |
|---|---|---|---|
| Pullers | BHP hydraulic pullers | Service kits, jaws, straps, handles, plungers | Pullers |
| Cutters | EBH bar cutters, EBC cordless bar cutters, EBE electric bar cutters, ECCE chain cutters, EWCH and EWCE wire and cable cutters, EFBE flat bar cutters, EDCH decommissioning cutters, ECSE cutter spreaders, STC cutter sets | Replacement blade kits, blade screws, head shear parts, service kits | Hydraulic Cutters and Electric Cutters |
| Presses | IP Series H-frame, XLP workshop and bench presses | Beams, brackets, base covers, handles, pins | Hydraulic Presses |
| Nut splitters | NSC nut splitters with integral pump and NSPH nut splitter cylinders | Wedges, cylinder bodies, O-rings, wrenches | Nut Splitters |
| Spreaders and flange spreaders | FS flange spreaders | Wedges, wedge tips, repair kits, fastener kits, balls, O-rings | Hydraulic Spreaders |
| Punches | SP35 35 ton punch | Repair kits, rams, springs | Hydraulic Hole Punches |
| Flange alignment | Flange alignment tools | Pins, kits, hardware | Enerpac Tools |
Cutter blades
Enerpac sells replacement blades for its cutters as kits named for the tool, for example the EBH5201K blade kit for the EBH52 bar cutter and the EWCH18001K kit for the EWCH180 wire and cable cutter. Each kit is one blade set. Order by the cutter model and confirm the kit number on the tool's repair parts sheet.
Press repairs
Enerpac IP Series H-frame presses are built around RC single-acting or RR double-acting cylinders, so the press frame parts are here while the cylinder parts are in Hydraulic Cylinder Repair Parts and the pump parts are in Hydraulic Pump Repair Parts. Check the press nameplate for the cylinder and pump model.
Keep your tools in service
- Keep dirt out. Enerpac warns that dirt in the system can cause pump, cylinder and valve failure. Cap couplers whenever a tool is disconnected.
- Use Enerpac oil. See Enerpac Hydraulic Oil.
- Rebuild with a kit. Service and repair kits are listed by tool model in Enerpac Repair Kits.
Hydraulic equipment should be serviced by a qualified hydraulic technician, as Enerpac's instructions state.
Finding the right part number
- Find the model number on the tool.
- Look up the repair parts sheet for that model; it lists every part by number and position.
- Match that part number to our listing. If anything does not match, call (704) 463-1070 before ordering.
All parts are in Enerpac Parts.
